In addition, the rip fence has an integrated workpiece support for wide workpieces, which also serves as a fence with a flat profile for sawing thin strips without having to remove the chip guard. Furthermore, it can be repositioned very quickly so that the maximum cutting width of over 82.5 cm can be used. The fence is absolutely parallel because it is guided by racks on the front and back. I think the system that DeWALT* uses here is great and very sturdy. The next point that was important for my decision is the rip fence. I really don’t understand why different slots were integrated in the GTS 10 XC. This means that the high-quality mitre fences from INCRA can be used with the DeWALT DWE7492! This is a strong argument against BOSCH. With DeWALT*, you can use standard T-track accessories with 19mm/23mm width. Unfortunately, the slots on the GTS 10 XC* are of different depths. The first really convincing point for me was the use of standardised T-slots in the saw table. I could not detect any warping of the rip fence. And what has been fixed once remains in this position. No matter whether it’s the saw blade adjustment or the very fine, minimal adjustment of the rip fence – nothing hangs here. The adjustment options are great and everything is very smooth-running without appearing to be of poor quality. Aside from solid wood, I have sawn various sheet materials (MDF, plywood, chip board) with the standard saw blade.

Now that I have finished my first projects with the DeWALT DWE7492* table saw, I am absolutely satisfied with the performance of the saw. Nevertheless, there are some differences between the two saws, which I will go into later. The saw blade size is also fairly similar at 254mm (Bosch) and 250mm (DeWALT). With 2,100 and 2,000 watts respectively, both the GTS 10 XC and the DWE 7492 should have enough power for the usual woodworking and DIY purposes. The power of both saws is probably quite comparable. But why did I chose the DeWalt DWE7492 in the end? And when might you be better off with the BOSCH*? I will try to get to the bottom of these questions in this article and the DeWalt DWE 7492* review. While I was dreaming of a BOSCH GTS 10 XC for a while, I was happy to have waited long enough to order the DeWalt DWE 7492. In particular I was askying myself the question “should I buy the DeWALT DWE7492* or the BOSCH GTS 10 XC*?”. Best Table Saw under 1000 Pounds?Įxactly the question from the headline is probably being asked by some people in the woodworking scene at the moment.

Find out why I chose the DeWalt DWE 7492 and what I think of the DeWalt DWE7492 table saw in this review!Īs an amazon associate i earn from qualifying purchases. You are looking for a table saw review because you can’t decide between the BOSCH GTS 10 XC and the new DeWalt DWE 7492? That’s the situation I was in.

Dewalt table saw fence